Table of Contents
Advertisement
ADCP-80-552 • Issue 2 • November 2000
2.2.2
DS3/E3 Test Ports
For each test set, connect the DS3/E3 test equipment ports as shown in
test equipment ports are located on the rear of the DSXpert chassis. They are used to connect
test equipment sets to the DSXpert units for monitoring and line testing. Two test sets are
supported. Use BNC cables, 75 ohm shielded coax for DS3/E3 test port connections.
Page 20
2000, ADC Telecommunications, Inc.
Figure 17. Connection of DS3/E3 Test Ports
Figure
17. The DS3/E3
14045-B
Advertisement
Table of Contents
