Table of Contents
Advertisement
AUTOTRONIC 5 - PowerShuttle - Programming and setting
A . Programming
- Switch on the ignition key to carry out this operation.
The engine must be stopped.
- The programming of the Autotronic 5 is necessary:
- if the former Autotronic 5 has been replaced by a
new one,
- when a new program becomes available to
improve the product,
- if the Autotronic 5 was programmed in a different
configuration (ParkLock, suspended front axle,
etc.).
N
: It is necessary to set Autotronic 5 parameters
OTE
after programming.
- Click on the "Tools" icon and then on "Programming
AUTO5" icon.
Wintest
AUTO5 label - PowerShuttle
Table of AUTO5 constants
Programming AUTO5
List of AUTO5 error codes
MA-11-01281A
Wintest - Issue 5.a
parameters
GUF511.3
Advertisement
Chapters
Table of Contents
