MASSEY FERGUSON 5400 Service Manual page 795

TR25: Intermediate speed sensor
Description
Location: close to the gearbox cover
Induction sensor.
- Connectors 1: Signal
- Connectors 2: Ground
Signals:
Resistance when stopped: 450 Ohm +/- 20
Alternating voltage when pinion is rotating
To adjust the air-gap:
- Apply a small amount of Loctite 5922 to the thread
- Screw the sensor home in abutment on the pinion
- Unscrew the sensor by 3/4 turn
- Tighten the locknut to approximately 6 Nm
Possible error codes
Errors Description
221 Intermediate speed sensor
error
WINTEST - Issue 5.a
AUTOTRONIC 5 - PowerShuttle - Error codes
(Fig. 16)
Solutions
Check:
- Sensor status
- Sensor resistance of 450 Ohm, as well as
alternating voltage when pinion is rotating
- Contacts
- Harness connections
- Wiring
TR24 TR16
MA-11-01264A
2
2
1
1
TR25
Fig. 16
MA-11-01265A
Fig. 17
Resetting the system
after clearing error
Press the clutch pedal to
contact the BOC
GUF513.17