Reassembly - MASSEY FERGUSON 5400 Service Manual

D . Reassembly
30. Check and clean all components. Replace any
defective parts.
If the thrust plate (29) has been replaced
31. Refit the plate.
32. Smear two screws (28) with Loctite 270, then
tighten to a torque of 90 - 120 Nm.
If the mechanism has been replaced
33. Refit the clevis (7) prepared with the stud (3) and
the pin (8). Replace the pin (9).
34. Fit the guide rod link (13) with its pin (6) on the stud
(3) of the clevis.
35. Refit the plate (5), tighten the nut (4).
N : The plate (5) is rectangular. It must be posi-
OTE
tioned horizontally so that the pin (6) fits correctly
on the link (13) (Fig.
36. Refit the discs (30), placing the mechanism (31)
between them.
N : Fit the guide rod link (13) on the finger (23).
OTE
Check that the discs slide freely on the shaft of the
drive pinion (26).
37. Place the snap ring (21) (if removed) on the pin (20).
38. Fit the pin (20) in the closing plate (24) with the
washer (22), the spring (17) and the seal (32).
39. Carry out operation
40. Check that the discs (30) and the mechanism (31)
are correctly positioned.
41. Fit and tighten the screws (25) to a torque of 90
-120 Nm.
42. Fit the cam (14) with its finger (16).
43. Place circlip (15). Tension the spring (17), posi-
tioning its ends E as indicated
44. Lightly smear the pin (20) with AS 767 Anti-Seize
grease or equivalent. Fit the seal (19) on the
housing and compress it to 5.8 ± 0.15 mm using a
retainer ring (33) (Fig.
Massey Ferguson 5400 - Issue 1.a
9).
21 in reverse order.
(Fig. 10).
11).
GPA20 handbrake unit and control
Fig. 9
Fig. 10
Fig. 11
06D01.9