Table of Contents
Advertisement
AUTOTRONIC 5 - Power Shuttle - Calibration and adjustments
D . Calibrating the (manoeuvring)
clutch pedal
Each time the clutch is disengaged then reengaged
(BOC then TOC), the Autotronic 5 gradually readjusts
its calibration parameters to centre the potentiometer
range correctly according to the pedal travel.
The calibration of the clutch pedal must be carried out
each time that one of the following elements is
replaced or modified:
- Clutch pedal progressivity potentiometer
- Autotronic 5
Method:
N
: The user has a maximum 0.5 second delay
OTE
between each operation to enter this mode.
- move Power Shuttle lever to neutral position
- move gear lever to neutral position
- move Power Shuttle lever to forward or reverse posi-
tion
- press the Hare / Tortoise control switch 10 times
- move Power Shuttle lever to neutral position
- press the clutch pedal fully in once, then release.
The pedal is calibrated.
GUF514.10
Wintest - Issue 5.a
Advertisement
Chapters
Table of Contents
