Table of Contents
Advertisement
Refitting
Refitting operations are not difficult. They therefore
require carrying out the removal operations in reverse
order.
However, during refitting it is necessary to ensure that:
- parts to be assembled are not dirty, corroded,
dented, etc.
- seals are oiled.
The locknuts fitted at the end of the spool valve set
should be tightened to a torque of 30 - 33 Nm.
Final operations
15. Check the correct operation of each spool valve on
the two, three or four positions (depending on
model).
16. Check the pressure on quick-disconnect couplings
(see Hydraulic tests, section 9).
Massey Ferguson 5400 - Issue 1.b
Auxiliary spool valve
09E01.13
Advertisement
Chapters
Table of Contents
