Table of Contents
Advertisement
N
: If work has been carried out but it was not
OTE
necessary to carry out J1 shimming (e.g.: replacement
of seals), shims (12) must be fitted at the left-hand end
(factory assembly) to secure the cam in the correct
position and to avoid adjusting the sensor (26).
36. Carry out shimming of the shaft (4)
obtain end play:
J1 = 0.10 to 0.20 maximum
Fit the arm (11), the washer (1) and the screw (2).
N
: grease the face of the cover (Anti-Seize
OTE
Grease or equivalent) before fitting the arms.
37. Tighten the screw to position the lift arms (5) and
(11) correctly on the shaft.
38. Measure the distance between face "A" of the
shaft and face "B" of the arm using a depth gauge
(Fig. 10
and
Fig.
11).
39. By measuring dimension "X", determine the thick-
ness of shims "Y" needed to obtain
J1 = 0.10 to 0.20 maximum
Y = X + J1
40. Fit the shims (12) selected previously
washer (1), the lockwasher (3) and the screw (2).
41. Tighten the screw (2) to a torque of 360 - 470 Nm.
For tractors fitted with 4-speed PTO, carry
out operations
42
42. Refit the finger (19)
43. Fit the O'ring (20) from the external side of the
cover
(Fig.
12).
44. Smear the screws (18) (22) with Loctite 241 and
tighten.
45. Check that the control functions smoothly.
46. Fit the elbow union (23).
Massey Ferguson 5400 - Issue 1.a
(Fig.
(Fig.
11):
(Fig.
to 46.
(Fig.
12).
11) to
11), the
GPA20 hitch / Linkage
Fig. 10
Fig. 11
Fig. 12
06F01.9
Advertisement
Chapters
Table of Contents
