ESAB A2 PEK Instruction Manual page 16

GB
For activating cold wire feed, a soft key, ICE WF, is activated, see chapter "Setting
soft keys" 8.2.3 . When the key is depressed, the cold wire speed is changed using
the left settings knob A. If the soft key is not depressed, the settings knob affects the
A current.
In the measurement display one can also see the set values if the soft key SET
VALUES is activated. If both soft keys, ICE WF and SET VALUES are activated, the
set feed speed for cold wire can be changed. For activating see chapter "Setting soft
keys" 8.2.3 .
300 cm/min
Set wire feed speed
20.0 Volt
Set arc voltage
30 cm/min
Set travel speed
2.1.5 Weld data memory menu
Main menu ³
In the WELD DATA
MEMORY menu you
can store, recall, delete
and copy various set
weld data. The weld
data sets can be stored
in 255 different memory
positions.
For further information, see the chapter 7 "Memory management".
bi24d1ea
SAW: CW
300 cm/min
V 20.0 Volt
30 cm/min
NONE NONE
WELD DATA MEMORY
1 (SAW)
7 (GMAW)
STORE
- 16 -
SET
VALUES NONE
2ND
FUNCT
|
|
|
|
|
|
2ND
FUNCT
QUIT
© ESAB AB 2009