A Copy Job Stops Before It Is Finished; The Power Save Indicator ( ) Is Lit Or Blinking; Any One Of The Alarm Indicators; Is Lit Or Blinking - Sharp AR-7024 Operation Manual

TROUBLESHOOTING
Problem
A copy job stops before it is
finished.
The POWER SAVE indicator (
lit or blinking.

Any one of the alarm indicators

( , , , , ) is lit or
blinking.

Lighting fixture flickers.

106
The paper output tray is full.
 Long copy runs are automatically paused every 250 copies.
Remove the copies in the paper output tray and press the
[START] key (
"FUL" appear in the number of copies display.*
 The memory became full during sort/group/rotate sort copy or
2 IN 1 / 4 IN 1 copy. Copy only the originals that have been
scanned to that point, or cancel the job and clear the data from
memory.
The tray is out of paper.
 Load paper.
Any other indicators are lit.
 If other indicators are lit, the machine is in "Preheat mode". Press
any key on the operation panel to resume normal operation.
) is
The POWER SAVE indicator (
 If only the POWER SAVE indicator (
is in auto power shut-off mode. Press the [POWER SAVE] key
( ) to resume normal operation.
See "INDICATORS AND DISPLAY MESSAGES" to check
the meaning of the alarm indicator and error message in
the display, and take appropriate action.
The same power outlet being used is for the lighting
fixture and the machine.
 Connect the machine to a power outlet which is not used for other
electric appliances.
Cause and solution
) to resume copying.
) is only blinking.
) is blinking, the machine
Page
48
60, 62
39
37
37
113
–