Table of Contents
Advertisement
2
INSTALLATION INSTRUCTIONS
All washers must be installed in accordance with all local, state and national
building, electrical, plumbing and other codes in effect in the area.
THESE INSTALLATION AND SERVICING INSTRUCTIONS ARE FOR USE
BY QUALIFIED PERSONNEL ONLY. TO AVOID INJURY AND ELECTRICAL
SHOCK, DO NOT PERFORM ANY SERVICING OTHER THAN THAT
CONTAINED IN THE OPERATING INSTRUCTIONS, UNLESS QUALIFIED.
2.1
FOUNDATION REQUIREMENTS
T-300 and 400:
This machine is designed for use on or over bare concrete floor - not to be
used above combustible flooring, such as carpet or wood. The washer
must be securely bolted to a substantial concrete floor, or mounted upon
a suitable base that is securely bolted to a substantial concrete floor.
Grouting is highly recommended, especially to the concrete surface. See
Machine Grouting section for details.
T-350, 450, 600, 650, 750, 900, 950, 1200, 1450, 1800:
This machine is designed for use on or over bare concrete floor - not to be
used above combustible flooring, such as carpet or wood. The washer
must be securely bolted and grouted to a substantial concrete floor or
mounted and grouted upon a suitable base that is securely bolted and
grouted to a substantial concrete floor. See Machine Grouting section for
details.
CARE MUST BE TAKEN WITH ALL FOUNDATION WORK TO ENSURE A
STABLE UNIT INSTALLATION, ELIMINATING POSSIBILITIES OF
EXCESSIVE VIBRATION.
Allow a minimum 24 inches (610 mm) of clearance behind the rear of the
machine to provide access for motor service.
Installation on an isolated pad is NOT recommended. Consult a structural
engineer for installations that will not be tied to a surrounding floor.
2.2
MOUNTING HEIGHT
A concrete pedestal or steel-mounting base that elevates the machine
above the floor level is suggested to provide easy access to the loading
door.
Suggested Amount to Elevate Washer:
T-300/350: approximately 8 inches (203 mm)
T-400/450/600: approximately 6 inches (152 mm)
T-650/750/900/950/1200/1450/1800: approximately 4 inches (102 mm)
Contact a Dexter laundry equipment distributor for recommended steel
8514-296-001 REV K page 7
WARNING:
Advertisement
Table of Contents
