Dexter Laundry T-1800 Operators Manual Installation & Operation Instructions page 62

Model
T-300
T-350 or T-350 SWD
T-400
T-450 or T-450 SWD
T-600
T-650
T-750 or T-750 SWD
T-900
T-950
T-1200
T-1450
T-1800
2. "Delay Fill" is meant to be used in applications where the amount of available
water pressure is limited. In these cases, the washer may not be able to fill the
tub in sufficient time to allow for effective washing performance.
When the "Delay Fill" option is "On", the water valves shall be turned on, the
washer shall agitate, but the cycle time shall be paused. The washer shall
continue in this state until the proper water level is reached. Once the proper
water level is reached, the cycle shall continue. A single selection of "On" or "Off"
shall apply to all baths in the cycle. The factory default setting is "Off".
3. "Delay Spin" is meant to be used in applications where the amount of drain
capacity is limited. In these cases the washer cannot empty the tub in sufficient
time to allow for a spin cycle to occur.
When a time value (other than 0) is programmed for the "Delay Spin" option, the
end of each bath will be extended by the selected time. Therefore, extra time
will be allowed for the drain valve to be open and compensate for slow drain
capacity. The factory default setting is 0 seconds.
4. "Default Temp" allows the user to choose which water temperature ("Hot",
"Warm", or "Cold") will be active during Idle mode. The customer can, of course,
choose other temperatures for the wash bath based on other options described
in this manual.
8514-296-001 REV K page 62
Adjustable Final Spin
Range
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 200G
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 100G