Removing The Seat Cover; Снятие Чехла - Cybex Platinum SOLUTION Z-FIX User Manual

Hide thumbs Also See for SOLUTION Z-FIX:
Table of Contents

Advertisement

REMOVING THE SEAT COVER

The seat cover consists of five parts which are fixed to the
seat with velcro, press studs or button holes. One you have
released the fasteners, the cover parts can be removed. To
remove the covers, please follow the instructions below:
Undo the press studs on the lower side of the cover for
the adjustable headrest. Then you can remove the cover
upwards.
Activate the adjustment handle for the headrest and move
this to its highest position.
Open and loosen all the press buttons on the rear side of
the headrest. Then pull the cover off forwards.
Pull down the cover on the left and right side panel of the
shoulder rest. Then undo the press studs on the interior of
the shoulder wings in order to be able to entirely remove
the cover.
Before you can remove the backrest cover from the seat,
undo the associated fastenings its rear side.
Then thread the elastic bands out on the underside of the
seat area, and withdraw the seat cushion cover forwards.
NOTE! Before removing the separate parts of the seat cover,
please ensure that the cover is already positioned above the
decorative silver parts. To put the covers back on the seat,
proceed as above in reverse order. Make sure that the red
!
belt guide )22( always rests visible above the seat cover.
WARNING! The infant car seat must under no
circumstances be used without the cover.
СНЯТИЕ ЧЕХЛА
Чехол для сиденья состоит из пяти частей, которые
закреплены застежкой-липучкой, кнопками или прорезями.
Как только вы раскроете фиксаторы, детали чехла
можно снять. Для снятия чехла, пожалуйста, следуйте
приведенным ниже инструкциям:
Расстегните кнопки на нижней стороне чехла
регулируемого подголовника. После этого вы можете
снять чехол.
Потяните за ручку регулировки подголовника и
переместите его в самое верхнее положение.
Откройте все кнопки на задней стороне подголовника.
Затем потяните чехол вперед.
Потяните вниз чехол на левой и правой боковой
панели плечевого упора. Затем расстегните кнопки на
внутренней стороне плечевой зоны для того, чтобы
иметь возможность полностью снять чехол.
Прежде чем вы снимите чехол спинки с сиденья,
раскройте соответствующие крепления на задней
стороне.
Затем спустите эластичные ленты на нижнюю сторону
сиденья и снимите чехол сиденья.
ВНИМАНИЕ! Перед снятием отдельных частей чехла,
пожалуйста, убедитесь, что чехол уже расположен над
декоративными серебряными частями. Чтобы чехол
на сиденье, действуйте, как указано выше в обратном
порядке. Убедитесь, что красная направляющая ремня
!
)22( всегда видна поверх чехла.
ВНИМАНИЕ! Автокресло не должна использоваться
без чехла.
33

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SOLUTION Z-FIX and is the answer not in the manual?

Questions and answers

Table of Contents