Table of Contents
Advertisement
Welding procedure
MIG/MAG welding
Non-latched mode
Step 1
•
Robot issues the start signal to the power source.
•
Shielding gas is expelled (gas pre-flows).
•
Wire feed motor runs at "creep speed".
•
Arc ignites after the wire electrode makes contact with the workpiece; welding current flows.
•
Changeover to pre-selected wire speed (main program P
Step 2
•
Robot issues the stop signal to the power source.
•
WF motor stops.
•
Arc is extinguished after the pre-selected wire burn-back time elapses.
•
Gas post-flow time elapses.
42
Figure 6-1
).
A
099-00L104-EW501
17.01.2022
Advertisement
Table of Contents
Need help?
Do you have a question about the L1.04 - RC XQ Expert 2.0 and is the answer not in the manual?
Questions and answers