Mig/Mag Welding - EWM L1.04 - RC XQ Expert 2.0 Operating Instructions Manual

5.6.3.1

MIG/MAG welding

In every JOB, separate settings can be made for the ignition program, reduced main program and end
program as to whether or not to alternate with the pulse process.
These properties are stored on the welding machine with the JOB. This means that in the factory settings,
the pulse process is active during the end program in all forceArc JOBs.
P , P and P
START B
feed value of the main program P
if desired (see Absolute value set point). > see 5.7.4 chapter.
Menu item/parameter
Gas pre-flow time
Gas nominal value
WF relative
Duration
U correction
Slope time
WF (/min.)
U correction
Duration
Slope time
WF relative
Duration
U correction
Slope time
Slope time
WF relative
Duration
U correction
Wire burn-back
Gas post-flow time
099-00L104-EW501
17.01.2022
are set as relative programs ex factory. They relate to percentages of the wire
END
. These programs can also be configured using absolute values,
A
Operating the machine control
Figure 5-13
Program Comment
GFE option/variant (electronic gas volume con-
trol) required
P Wire feed speed, relative
START
Duration (start program)
Arc length correction
Slope duration from P
P Wire feed speed, absolute
A
Arc length correction
Duration (spot time and superPuls time)
Slope duration from P
P Wire feed speed, relative
B
Duration (reduced main program)
Arc length correction, relative
Slope duration from P
Slope duration from P
P Wire feed speed, relative
END
Duration (end program)
Arc length correction, relative
Welding task administration (Menu)
to P
START A
to P
A B
to P
B A
to P
B END
35