Table of Contents
Advertisement
Factory Reset
Reset Button
The reset button is located on the bottom of the unit next to the connector.
•
Press and hold the button for >10 seconds and then release it to reset to the
factory default settings when the unit is powered on.
•
Press and hold the button during startup to enter Recovery Mode.
Recovery Mode
If the web interface cannot be accessed, the unit may be reset by starting in Re-
covery Mode and reinstalling the firmware using Anybus Firmware Manager II.
For instructions, please refer to the wizard in Anybus Firmware Manager II.
Anybus
®
Wireless Bolt
™
Firmware updates should normally be carried out through the web
interface. Recovery Mode should only be used if the Wireless Bolt is
unresponsive and the web interface cannot be accessed.
Installation Guide
11 (16)
SCM-1202-006/SP2139 1.7
Advertisement
Table of Contents
Need help?
Do you have a question about the Anybus Wireless Bolt and is the answer not in the manual?