Installation; Preliminary Operations - Jet Helmets Or Flip-Up Helmets; Fig. 1 - Nolangroup n-com bluetoothkit X Series User Instructions And Safety

3. INSTALLATION

3.1. Preliminary operations – Jet helmets or Flip-up helmets

Fig. 1

 Open the helmet chin guard (only on Flip-up helmets).
 Pull out both comfort cheek pads, left and right, from the helmet. (Fig. 1)
 Remove the noise reducers from the cheek pads (if present) and cut the insert using
a pair of scissors, following the pre-cut dots. Reposition the noise reducers in the
removable cheek pads.
 Take out the rear section of the comfort padding, pulling on the neck roll until it is
released from the shell. Reposition the padding on the outside of the helmet for the
time being.
 Unhook the press-stud of the polystyrene cheek pads by pulling toward the inside of
the helmet (Fig. 2), then remove the cheek pad by pulling it upward.
Warning: in case the polystyrene cheek pad is damaged during this operation, please
contact your local dealer to replace it.
 Cut out the round foam insert that covers the speaker housing from the polystyrene
cheek pad using a pair of scissors, following the pre-cut dots. (Fig. 3).
Fig. 2
Fig. 3
9