Intercom Function; Intercom Via Cable - Nolangroup n-com bluetoothkit X Series User Instructions And Safety

N.B.: In case a cell phone was already affiliated prior to the affiliation of the Bluetooth
Kit systems, make sure that this affiliation is still working. Otherwise, repeat the
affiliation with the cell phone.
All affiliations are stored even when the helmets are turned off, and they are
maintained until the helmets are turned back on. As a result, the affiliation procedure
must be repeated only when systems other than the affiliated ones are used.
11.3.

Intercom function

After carrying out the proper pair up procedure, turn on the two helmets. Intercom
connection will be established automatically (this will take a few seconds. Wait until
you hear the acoustic signal confirming the operation).
If automatic connection is not possible, proceed with the manual connection.
Manual intercom activation
Manual intercom
deactivation
The system is equipped with a "MUTE" function that turns off the microphone yet
leaves the audio channel open. This function can be used to listen to an audio source,
eliminating any interference picked up by the microphone of the connected helmet.
Switching the
microphones on/off
(Mute function)
11.4.

Intercom via cable

In order to use N-Com Bluetooth Kit X-Series as intercom via cable, you need to use
an Intercom Wire (sold separately) to connect the two helmets.
Install the Bluetooth Kit X-Series in the Rider's helmet.

26
With Bluetooth Kit X-Series turned on, briefly press
"on".
With Bluetooth Kit X-Series turned on, briefly press
"on".
Press the "-" button and keep it pressed for about 4
seconds.