Audio Devices With Cable Connection - Nolangroup n-com bluetoothkit X Series User Instructions And Safety

Next track (Skip)
Stop playing music (Stop)
Note: The Bluetooth intercom does not work while listening to an A2DP audio source.
Note: If you connect a second helmet via cable in interphone mode, the person
wearing this helmet can listen to music played by the receiver (audio in Mono
mode).

10. AUDIO DEVICES WITH CABLE CONNECTION

The range of N-Com products offers various "Multimedia Wire" accessories for
connection to external audio devices: MP3 players, i-Pods, Satellite navigators, GMRS
and PMR radio and audio systems pre-fitted on motorcycles (MCS).
To find out about all the available cables, please visit the website www.n-com.it in the
"Cable connection compatibility" section.
Note: Connect the 3.5-mm 4-pole connector of the Multimedia Wire to the helmet and
the other end to the audio device. A coloured band on the cable indicates the
connector to be hooked up to the audio device
Turning on the audio
device
Turning off the audio
device
The Bluetooth Kit X-Series can be connected with cables of the N-Com range of both
the Mono type (Multimedia Wire or Mobile Wire) and Stereo type (Multimedia Wire2).
The Bluetooth Kit is pre-set to receive stereo cables, nevertheless when it is turned on
a check is carried out on the type of connected cable. If you plan on connecting a Mono
24
When the player is playing music, press "+" for 4 about
seconds.
Press "-" for 2 seconds. The music stops and the A2DP
player is disconnected.
Press "+" and keep it pressed for 2 seconds.
Press "-" and keep it pressed for 2 seconds.