Removing The System; Basic Functions; Pairing Up Bluetooth Devices - Nolangroup n-com bluetoothkit X Series User Instructions And Safety

4. REMOVING THE SYSTEM

To remove the system from the helmet, proceed as per the installation by removing
the various components.
The adhesive keyboard can be removed in case the system is no longer used.
However, it will not be possible to reuse it since it will have lost its adhesive properties.
You can purchase a replacement keyboard if you wish to install the system again.

5. BASIC FUNCTIONS

All the functions offered by the N-Com system are activated by using 3 buttons, "+",
"on" and "-". Every command is confirmed by a special beep, which varies depending
on the requested function. This way you can use all the functions with the helmet
raised.
The type of command given to the system depends on how long the button is pressed.
Turning on
Turning off
Raising the Volume
Lower volume

6. PAIRING UP BLUETOOTH DEVICES

In order for the Bluetooth Kit X-Series system to be connected to another Bluetooth
device, the latter needs to be first paired up with the N-Com system.
The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3
Bluetooth players, satellite navigators, etc.
1. Make sure the Bluetooth Kit X-Series is turned off;
20
Press the "on" button and keep it pressed for about 4 seconds
until the LED lights up and a beep is heard in the earphone
Press the "on" button and keep it pressed for about 4 seconds
until the LED turns off and you hear a beep.
Press the "+" button briefly to raise the volume. The
maximum volume is signaled by a double beep.
Press the "-" button briefly to lower the volume. The minimum
volume is signaled by a double beep