Nolangroup n-com bluetoothkit X Series User Instructions And Safety page 21

2. Press "on" and keep it pressed (for more than 4 seconds), until the LEDs
start to flash quickly and you hear a sharp beep in the headset, indicating
the "Pair-up mode";
3. On the Bluetooth device, turn on the search for Bluetooth devices (refer to
the instructions manual of your device for the proper pairing up procedure,
as it varies depending on the brand and model of the device);
4. After a few seconds, the mobile phone will display the name "N-ComX 1.XX",
followed by the manufacturer's identification data;
5. Select the N-Com device. If a password is requested, enter 0000 (four
zeros);
6. Bluetooth Kit X-Series will confirm the pairing up by means of a tone in the
headset, and the LEDs will stop flashing;
7. Turn off and on both the mobile phone and the Bluetooth Kit X-Series to
store the pairing up data.
Note: If you need to repeat the procedure, turn off the system and start from point 1.
The affiliation procedure can be repeated multiple times without the risk of
damaging the system.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost
when the two devices are turned off. As a result it needs to be carried out only
once.
Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with
Bluetooth A2DP player has already been paired up, the pairing up DOES NOT
have to be repeated as the A2DP protocol has already been stored in the
Bluetooth Kit X-Series.
Once the Bluetooth device has been paired up, connection is automatic when the
system is turned on. You can nevertheless connect or disconnect from the helmet
(see the controls diagram below) or from the mobile phone.
Connection To connect the cell phone (or other Bluetooth devices) to
Bluetooth Kit press the "on" key and keep it pressed for about
2 seconds (until you hear a beep)
21