Affiliation Reset Function; Mobile Phone Functions - Nolangroup n-com bluetoothkit X Series User Instructions And Safety

Disconnection
6.1.

Affiliation reset function

You can remove all affiliated devices from the system memory. This operation is not
reversible; right after resetting, you will have to repeat the affiliation procedure for the
cell phone (or for other compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
Put the system in affiliation mode (press the "on" button until the LEDs start to

flash quickly).
With the helmet in affiliation mode, press both buttons "+" and "-" at the same

time for 2 seconds and release them when you hear a beep. The system will
emit a special beep to confirm the operation.

7. MOBILE PHONE FUNCTIONS

Answering a call
Hanging up/rejecting a
call
Vocal call
Calling back last number
Call transfer (HFP profile)
22
To disconnect the cell phone (or other Bluetooth devices) from
Bluetooth Kit, press both "+" and "-" buttons at the same time
and keep them pressed for 2 seconds
Press any button briefly when you hear the ring tone.
To end a call or reject an incoming call, press the "on"
button and keep it pressed for about 2 seconds (until
you hear a beep).
N.B.: Cell phones affiliated in HSP (Headset profile)
mode do not allow calls to be rejected
To make vocal calls (in case of cell phones that allow it)
or give other vocal commands, press the "on" key and
keep it pressed for about 2 seconds (until you hear a
beep)
To call back the last number dialed, press both "+" and
"-" buttons and release them at the same time
To transfer a call in progress from the helmet to the cell
phone, press both "+" and "-" buttons at the same time
and keep them pressed for 2 seconds