Installing The Adhesive Keyboard - Nolangroup n-com bluetoothkit X Series User Instructions And Safety

3.3.

Installing the adhesive keyboard

Fig. 11
Remove the N-Com plug from the left side of the helmet; to make this easier, it is

recommended to push the plug from the inside of the helmet. (Fig. 11)
Thoroughly clean the outside surface of the shell to make sure that the adhesive

keyboard sticks properly. Before you apply the keyboard, make sure that the shell
area is completely clean and grease or dirt free.
Remove the protective film from the back of the adhesive keyboard using the

special tab. (Fig. 12)
Pass the Flex cable of the keyboard through the hole in the outer shell. (Fig. 13)

Fig. 14
12
Fig. 12
Position the keyboard on the shell.

Only for Jet helmets or flip-up helmets: Carry
out the operation with the chin guard open, as
shown in figure 14.
Apply the keyboard to the shell and press

down on its entire surface to make sure that
it sticks properly.
Note: In the event that the keyboard is not
positioned correctly, peel it off right away
with extreme care and repeat the positioning.
Note: It takes up to 24 hours for the keyboard to
stick completely. During this time, do not
expose the helmet to atmospheric agents.
Fig. 13