Adjusting Program Schedules; Overriding Schedules Temporarily; Overriding Schedules Permanently; Unregistering Thermostat - Honeywell Home FocusPRO Wi-Fi Series User Manual

Adjusting program schedules

1 Press Set Clock/Day/Schedule, then Set Schedule.
2 Press s or t to set your Monday (Mon) Wake time, then press Next.
3 Press s or t to set the temperature for this period, then press Next.
4 Set time and temperature for the next time period (Leave). Repeat Steps 2 and 3 for
each time period.
5 Press Next to set time periods for the next day. Repeat Steps 2 through 4 for each
day.
6 Press Done to save and exit.
Note: Make sure the thermostat is set to the system mode you want to program (Heat
or Cool).

Overriding schedules temporarily

Press s or t to immediately adjust the temperature.
The new temperature will be maintained only until the next programmed time period
begins.
To cancel the temporary setting at any time, press Cancel. The program schedule will
resume.

Overriding schedules permanently

1 Press HOLD to permanently adjust the temperature. This will turn off the program
schedule.
2 Press s or t to adjust the temperature setting. The temperature you set will be
maintained 24 hours a day until you manually change it or press Cancel to resume
the program schedule

Unregistering thermostat

If you remove the thermostat from your Total Connect Comfort website account
(for example, you're moving and leaving the thermostat behind), the thermostat will
display Register at Total Connect until it is re-registered.

Disconnecting Wi-Fi

Replacing your router
If you disconnect the thermostat from your Wi-Fi network:
1 Enter system setup (see page 10).
2 Change setting 39 to 0 (see page 10).
The screen will display Wi-Fi Setup.
Re-connect to a Wi-Fi network by following the steps on page 3.
Turning Wi-Fi off
If you do not plan to control the thermostat remotely, you can remove the Wi-Fi Setup message from the screen:
1 Enter system setup (see page 10).
2 Change setting 38 to 0 (see page 10). Wi-Fi Setup will be removed from the screen. If you want to connect to
the Wi-Fi network later, change setting 38 back to 1.
8
M38877
HOLD
M38878
HOLD
M38879
M38880
M38881