Connecting To Your Wi-Fi Network - Honeywell Home FocusPRO Wi-Fi Series User Manual

Connecting to your Wi-Fi network

Connect your wireless device to your home network. Any of these device types will work:
• Tablet (recommended)
• Laptop (recommended)
• Smartphone
If you get stuck... at any point in this procedure, restart the thermostat by removing the thermostat from the wallplate, wait for
10 seconds, and snap it back onto the wallplate. Go to "Advanced Wi-Fi setup" on page 5.
1 Connect to your thermostat.
1a Make sure the thermostat displays Wi-Fi SETUP.
1b On the wireless device (tablet, laptop, smartphone), view the list of available Wi-Fi networks.
1c Connect to the network called NewThermostat_123456 (the number will vary).
Note: If you are asked to specify a home, public, or office network, select Home Network.
Note: If the Wi-Fi setup is not working as described in this section, go to "Advanced Wi-Fi setup"
on page 5.
2 Join your home network.
2a Open your web browser to access the Thermostat Wi-Fi Setup page. The browser should
automatically direct you to the correct page; if it does not, go to http://192.168.1.1
2b Find the name of your home network on this page and select it.
Note: Some routers have enhanced features such as guest networks; use your home network.
2c Complete the instructions for joining your Wi-Fi network and click on the Connect button.
(Depending on your network setup, you may see an instruction such as Enter Password for your
home network.)
Note: If you did not correctly connect to the thermostat, you may see your home router page. If so,
return to Step 1.
Note: If your Wi-Fi network does not appear in the list on the Thermostat Wi-Fi Setup page:
• Try performing a network rescan by pressing the Rescan button. This is helpful in areas with a lot of networks.
• If you are connecting to a hidden network, then enter the network SSID in the textbox, select the encryption type from the drop
down menu, and click on the Add button. This manually adds the network to the top of the list. Click on the new network in the
list and enter the password if necessary. Click on Connect to join the network.
3 Make sure your thermostat is connected.
While the connection is in process, your thermostat will flash Wait for up to 3 minutes. When the
connection is complete, the display will show Wi-Fi Setup Connection Success. The Wi-Fi signal strength
will appear in the top-right corner.
After about 60 seconds, the home screen will appear and Register at Total Connect will flash until
registration is complete.
To register online for remote access to your thermostat continue on page 4.
Note: If the thermostat displays Connection Failure or continues to display Wi-Fi Setup, confirm you correctly
entered your home network password in step 2.
3
HOLD
M38870
M38871
M38880