Removing And Installing The Dimm; Statement 94 - Cisco CISCO7201 Installation And Configuration Manual

Removing and Installing a DIMM
Remove the Cisco 7201 router from the rack, if it is rack-mounted.
Step 5
Figure 4-13
TH IS UN
IT MA Y
1 Cover screws
Step 6 Turn the Cisco 7201 so that the back is facing you.
Step 7 Using a Phillips screwdriver, loosen the fifteen cover screws holding the cover to the chassis.
Step 8 Lift the cover off the router.
Proceed to the following sections for replacement instructions:
•
•

Removing and Installing the DIMM

The information in this section provides instructions for replacing the DDR-SDRAM DIMM and is
included for future use. The memory configuration you ordered is installed in the Cisco 7201 router.
During these procedures, wear grounding wrist straps to avoid ESD damage to the card. Do not
Warning
directly touch the backplane with your hand or any metal tool, or you could shock yourself.

Statement 94

Cisco 7201 Installation and Configuration Guide
4-16
Removing the Cover
HA VE MO
RE TH AN
ON E PO
WE R SU
PP LY CO
NN EC TIO
N. AL L
CO NN EC
TIO NS MU
ST BE RE
MO VE D
TO DE -EN
ER GIZ E
TH E UN
IT
Removing and Installing the DIMM, page 4-16
Replacing the Cover and Powering On the Router, page 4-18
Chapter 4
1
Replacing Cisco 7201 Field-Replaceable Units
OL-11364-04