Removing and Installing a DIMM
Replacing the Cover and Powering On the Router
The Cisco 7201 router cover fits tightly on the chassis. Follow these instructions to replace the cover and
power on the router:
Figure 4-15
TH IS UN
IT MA Y
1
Step 1
Place the cover on the top of the router with the four-screw edge aligned with the front of the router, and
the five-screw edge aligned with the rear of the router.
Step 2
Insert and tighten the fifteen cover screws with a Phillips screwdriver.
Step 3
Return the router to its installation site, attach the ground cable, and input/output and power cables.
Step 4
Power on the router by turning the power switch to the on position.
This completes the installation of the DIMM and replacement of the cover.
Cisco 7201 Installation and Configuration Guide
4-18
Inserting the Screws and Replacing the Cover
HA VE MO
RE TH AN
ON E PO
WE R SU
PP LY CO
NN EC TIO
N. AL L
CO NN EC
TIO NS MU
ST BE RE
MO VE D
TO DE -EN
ER GIZ E
TH E UN
IT
Cover screws
Chapter 4
1
Replacing Cisco 7201 Field-Replaceable Units
OL-11364-04