Cisco CISCO7201 Installation And Configuration Manual page 76

Configuring a Cisco 7201 Router
The first two sections of the configuration script (the banner and the installed hardware) appear only at
initial system startup. On subsequent uses of the setup facility, the script begins with a System
Configuration Dialog as shown in the following example.
--- System Configuration Dialog ---
Step 2 When asked if you would like to enter the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system,
extended setup will ask you to confiuure each interface on the system.
When asked if you want to enter the basic management setup, enter no.
Step 3
Would you like to enter the basic management setup [yes/no]: no
Step 4 When asked if you want to enter the initial configuration dialog and see the current interface summary,
enter yes or press Return:
First, would you like to see the current interface summary? [yes]:
In the following example, the summary shows a Cisco 7201 router at first-time startup; that is, nothing
is configured.
Interface
FastEthernet0/0
GigabitEthernet0/0 unassigned
GigabitEthernet0/1 unassigned
GigabitEthernet0/2 unassigned
GigabitEthernet0/3 unassigned
Choose which protocols to support on your interfaces. For Internet Protocol (IP)-only installations, you
Step 5
can accept the default values for most of the questions. A typical configuration using IP, IPX, and
AppleTalk follows and continues through
Configuring global parameters:
Enter host name [Router]:
Enter enable secret, enable, and virtual terminal passwords:
Step 6
The enable secret is a password used to protect access to privileged EXEC and
configuration modes. This password, after entered, becomes encrypted in the configuration.
Enter enable secret: barney
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: betty
The virtual terminal password is used to protect access to the router over a network
interface.
Enter virtual terminal password: fred
Cisco 7201 Installation and Configuration Guide
3-12
IP-Address OK? Method
unassigned NO unset
NO unset
NO unset
NO unset
NO unset
Step 10:
Chapter 3 Starting and Configuring the Router
Status Protocol
up up
up up
up up
up up
up up
OL-11364-04