Cisco CISCO7201 Installation And Configuration Manual page 102

Removing and Installing an AC Power Supply
Figure 4-6
1
AC power receptacle
Swing the cable-retention clip to the left.
Step 3
Unplug the AC power cable from the power supply.
Step 4
Figure 4-7
. AL L CO
NN EC TIO
NS MU ST
BE RE MO
VE D TO
1 Power up restrictor
2 Upper power supply captive installation screw
Step 5 Move the power up restrictor to the left to gain access to the upper power supply captive installation
screw.
Step 6 Unscrew the upper power supply captive installation screw while holding the power up restrictor to the
left, then release the power up restrictor.
Step 7 Unscrew the lower power supply captive installation screw.
Step 8 Grasping the captive installation screws, pull the power supply from the chassis.
Cisco 7201 Installation and Configuration Guide
4-8
Removing the AC Power Cable
2
Removing the AC Power Supply
DE -EN ER
GIZ E TH
E UN IT
2
Chapter 4 Replacing Cisco 7201 Field-Replaceable Units
1
2
AC power cable-retention clip
3 Lower power supply captive installation
screw
OL-11364-04