Cisco CISCO7201 Installation And Configuration Manual page 108

Removing and Installing a DC Power Supply
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than: 120 VAC, 20A U.S. (240 VAC, 10A international).
Statement 1005
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
At the front of the router, make sure the power switch is in the standby (|) position.
Step 1
Check to make sure the power supply LEDs are off.
Step 2
Step 3 Move the circuit-breaker switch handle to the off position, and apply tape to hold it in the off position.
Figure 4-12
1
Tie wrap
Caution Secure the wires coming in from the terminal block plug so that they cannot be disturbed by casual
contact.
Cisco 7201 Installation and Configuration Guide
4-14
Inserting the Terminal Block Plug in the Block Header
1
2
Chapter 4 Replacing Cisco 7201 Field-Replaceable Units
2
Terminal block plug
OL-11364-04