Removing And Replacing Micro-Usb; Removing And Replacing A Dimm; Removing A Dimm - Cisco Catalyst 8500 Series Hardware Installation Manual

Removing and Replacing Micro-USB

Removing and Replacing Micro-USB

The Cisco Catalyst 8500 Series Edge Platform contain one micro-USB port to store configurations or Cisco
IOS XE consolidated packages. To remove and then replace a USB flash memory stick, follow these steps:
To remove and then replace a USB flash memory stick, follow these steps:
Procedure
Step 1
Pull the flash memory stick from the USB port..
Step 2 To replace a Cisco USB Flash memory stick, insert the module into USB port 0 or 1. The Flash memory stick
can be inserted only in one way, and can be inserted or removed regardless of whether the router is powered
up or not.

Removing and Replacing a DIMM

The Cisco Catalyst 8500 Series Edge Platform has two DIMM slots and supports 16-GB configuration by
default.
Table 5: Supported Slots for Inserting the DIMMs
Memory PID Option
MEM-C8500-16GB
MEM-C8500-32GB
MEM-C8500-64GB

Removing a DIMM

Before you begin
Perform the following steps before you begin the process of removing and replacing a DIMM from a Cisco
Catalyst 8500 Series Edge Platform:
• Use an ESD-preventive wrist strap.
• Back up the data that you want to save.
• Remove the power supplies before you remove the chassis top cover.
Cisco Catalyst 8500 Series Edge Platforms Hardware Installation Guide
42
Memory Channel B
Slot 0 (U1DA0)
8 GB
16 GB
32 GB
Removing and Replacing FRUs
Slot 2 (U1DB0)
8 GB
16 GB
32 GB