Cisco CISCO7201 Installation And Configuration Manual page 100

Removing and Installing a Port Adapter or Service Adapter
Figure 4-4
2
1
Port adapter lever
2
Port adapter
Follow these steps for inserting and securing a port adapter:
Attach an ESD-preventative wrist strap between you and an unpainted chassis surface.
Step 1
Disconnect all cables from the port adapter.
Step 2
Remove the port adapter from the chassis slot by sliding the port adapter lever to the right, in the
Step 3
unlocked position.
Grasp the handle and pull the port adapter or port adapter blank panel from the router.
Step 4
Locate the port adapter slot guides inside the Cisco 7201 router. They are near the top, and are recessed
Step 5
about one-half inch.
Caution The port adapter must slide into the slot guides under the chassis lid. Do not allow the port adapter
components to come in contact with the system board or the port adapter could be damaged.
Step 6 Carefully slide the port adapter into the port adapter slot and seat it. When installed, the port adapter
input/output panel should be flush with the face of the router.
Slide the port adapter lever left to the locked position.
Step 7
Step 8 Reconnect any cables, including the port adapter and power cables, and place the cables through any
cable-management bracket or power cable-retention clip.
Power on the router by turning the power switch to the on (O) position.
Step 9
Note
Cisco 7201 Installation and Configuration Guide
4-6
Installing a Port Adapter or Service Adapter
3
GIGAB IT ETHE
SLOT 1
RNET 0/0
RJ45 EN
LINK
RJ45 EN
TX GBIC
Cis co 720 RX
1
RJ45 EN
LINK/ ACTV
SFP
ATM
CIS CO 730
1
GE 0/0
1
If the port adapter fails to come up, reseat or reinsert the port adapter: do not use excessive force.
Chapter 4
GIGAB IT ETHE
RNET 0/1
LINK GIGAB IT ETHE
RNET 0/2
TX GBIC RJ45 EN
RX
LINK AUX
CONS OLE
TX CONS OLE
GBIC
RJ45 RX
EN LINK/ ACTV
TX SFP LINK/ ACTV
RX 100-2 40V,
SFP LINK/ ACTV 2A, 50/60
24V= 9A, Hz
TX SFP 48 - 60V=
RX ALAR M 5A
MNGM NT
USE ONLY COMP ACT
FLASH
GE 0/1 STATU S
GE 0/2 ALAR M
GE 0/3
AUX
PWR OK
FE 0/0 FE 0
LINK
STATU S
COM PAC T
FLA SH
CF
ACTV
3
Port adapter slot guide
Replacing Cisco 7201 Field-Replaceable Units
OL-11364-04