Removing and Installing an SFP Module
Removing and Installing an SFP Module
For SFP module specifications and product numbers, see
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Warning
Class 1 laser product. Statement 1008
Warning
Class 1 LED product. Statement 1027
For general information about SFP modules, see the
Removing an SFP Module
Use the following procedure to remove an SFP module:
Make sure there is no traffic flowing through the native Gigabit Ethernet port.
Step 1
Remove the optical fiber cable, taking care not to touch the connector.
Step 2
Step 3
Pull gently to detach the SFP module from the chassis.
Step 4
Insert a plug into the SFP module.
Installing an SFP Module
Use the following procedure to install an SFP module:
Figure 4-1
1
Cisco 7201 Installation and Configuration Guide
4-2
Inserting an SFP Module into the Cisco 7201 Gigabit Ethernet Port 0/1
C i s c o 7
2 0 1
R J4 5 E
N
LI N K /A C TV
S FP
R J4 5
E N
LI N K /A C TV
TX
S FP
R X
G E 0/ 0
G E 0/ 1
2
Gigabit Ethernet port 0/1—SFP port
Chapter 4
Appendix A, "Specifications."
"SFP Module Information" section on page
C O N S O LE
LI N K /A C TV
LI N K /A C TV
S FP
TX
S FP
R X
M N G M N T
U S E O N LY
G E 0/ 2
G E 0/ 3
A U X
FE 0/ 0
1
2
SFP module
Replacing Cisco 7201 Field-Replaceable Units
0
FE
LI N K
1-5.
OL-11364-04