Document Organization - Cisco CISCO7201 Installation And Configuration Manual

Audience
Audience
This publication is primarily designed for the person responsible for installing, maintaining, and
troubleshooting the Cisco 7201 router. The users of this guide should be familiar with electronic
circuitry and wiring practices and have experience as electronic or electromechanical technicians. Users
of this guide should also have experience in installing high-end networking equipment. Certain
procedures described in this guide require a certified electrician.
For configuration applications, refer to the Cisco IOS configuration guides and command references and
to the documents listed in the

Document Organization

The major sections of this installation and configuration guide are as follows:
Chapter and Appendix Number and Title
Chapter 1, "Overview"
Chapter 2, "Installing the Cisco 7201 Router"
Chapter 3, "Starting and Configuring the Router"
Chapter 4, "Replacing Cisco 7201 Field-Replaceable Units"
Chapter 5, "Troubleshooting Initial Startup Problems"
Appendix A, "Specifications"
Appendix B, "Using the CompactFlash Disk"
Appendix C, "Configuration Register Information"
Safety Warnings and Cautions
Most safety warnings for the Cisco 7201 router are placed in relevant sections throughout the document.
For translated safety warnings, see the
Series
warnings.
Translated warning statement numbers are listed at the end of each warning. They correspond to the
translated safety warning statement numbers found in translated warning statement headings in the
Regulatory Compliance and Safety Information for Cisco 7200 Series Routers
Cisco 7201 Installation and Configuration Guide
x
"Related Documentation" section on page
Routers. Below is Statement 1071, the Warning Definition statement, complete with translated
Description
This chapter provides an overview of the Cisco 7201.
This chapter provides preparation and installation
instructions for installing the chassis in a rack and for
attaching cables.
This chapter provides a functional overview of the
system as well as startup and configuration instructions.
This chapter provides instructions for removing and
replacing power supplies, SDRAM, CompactFlash
disks, USB memory, SFP modules, and port adapters
and service adapters.
This chapter provides basic system startup
troubleshooting information.
This appendix provides system specifications as well as
port and cabling pinouts and specifications.
This appendix provides instructions for using the
CompactFlash Disk.
This appendix provides configuration register
information.
Regulatory Compliance and Safety Information for Cisco 7200
Preface
xvii.
document.
OL-11364-04