Using The Mkdir Command - Cisco CISCO7201 Installation And Configuration Manual

Working with a CompactFlash Disk
If you order a spare CompactFlash Disk, it is shipped blank; therefore, you must format it before you
Note
can use it.
Use the following procedure to format a new CompactFlash Disk using the format command. (The
procedure assumes you have already booted your system.)
Insert the CompactFlash Disk into slot 0 using the procedures in the
Step 1
CompactFlash Disk" section on page
Use the format disk0: command to format the CompactFlash Disk in slot 0 as follows:
Step 2
Router# format disk0:
Format operation may take a while. Continue? [confirm]
Format operation will destroy all data in "disk0:".
Format: Drive communication & 1st Sector Write OK
Writing Monlib
sectors..........................................................
.................................................................
....
Monlib write complete
Format: All system sectors written. OK...
Format: Total sectors in formatted partition: 125152
format: Total bytes in formatted partition: 64077824
Format: Operation completed successfully.
Format of disk0 complete
Note
The new CompactFlash Disk is now formatted and ready to use in the system on which you formatted it.
(For specific formatting and compatibility requirements, see the
on page

Using the mkdir Command

To create a directory on the CompactFlash Disk, use the mkdir command. The following example shows
how to create a directory called daily_dir on the CompactFlash Disk in slot 0, and then verify that it was
created:
System# mkdir disk0:daily_dir
Created dir disk0:daily_dir
System# dir
Directory of disk0:/
1
48755200 bytes total (48751104 bytes free)
System#
Cisco 7201 Installation and Configuration Guide
B-10
A 64-MB CompactFlash Disk was formatted in this example.
B-2.)
drw- 0 Jul 25 1998 10:15:43
4-3.
Continue? [confirm]
daily_dir
Appendix B Using the CompactFlash Disk
"Removing and Installing the
"Compatibility Requirements" section
OL-11364-04