Rommon Prompt: Rommon - Cisco CISCO7201 Installation And Configuration Manual

ROMmon Prompt: rommon >
Reload the router using the reload command. Do not save the configuration.
Step 4
7201(boot)# reload
System configuration has been modified. Save? [yes/no]: no
[confirm]
System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1) Technical Support:
http://www.cisco.com/techsupport
Socket jumper: not present Failsafe jumper: present = normal FPGA revision 0x00000015
C7200 platform with 1046528 Kbytes of main memory
Readonly ROMMON initialized
rommon 1 >
The router should now be in ROMmon mode (rommon >). Follow the instructions in the
Prompt: rommon >" section on page 5-10
For an example of this complete process, see the
Example" section on page
ROMmon Prompt: rommon >
Use this procedure to recover a router stuck in ROMmon mode at the: rommon > prompt.
Check the contents of the flash file system by entering the dir file-system: command:
Step 1
rommon 1> dir disk0:
2
6a
234317816 bytes available (22132744 bytes used)
Step 2 If the flash file system has a valid Cisco IOS image, follow the instructions in step a. If the flash file
system does not have a valid Cisco IOS image, follow the instructions in step b.
a.
rommon 2 > boot disk0:c7200p-js-mz
Self decompressing the image :
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
############################################# [OK]
<some output removed for brevity>
Cisco 7201 (c7201) processor (revision B) with 917504K/65536K bytes of memory.
Processor board ID 74832279
MPC7448 CPU at 1666Mhz, Implementation 0, Rev 2.2
1 slot midplane, Version 2.0
Cisco 7201 Installation and Configuration Guide
5-10
5-11.
22132744 Jan 22 2007 18:29:48 +00:00 c7200p-js-mz
If a flash file system has a valid Cisco IOS image, boot the router using the boot
file-system:image-name command.
Chapter 5
Copyright (c) 2006 by cisco Systems, Inc.
to boot the router from ROMmon.
"Complete Boot Prompt and ROMmon Prompt
Troubleshooting Initial Startup Problems
"ROMmon
OL-11364-04