Setting - Delta Electronics MVF2000 Series Product Manual

This interface aims at recording all the events about alarms, faults, equipment start-up
and shut-down to the logs.

3-5 Setting

Press "Setting" button in the HMI main menu to enter into the operation mode interface,
as shown in Fig. 3-10.
This interface can be used to conduct setup in the operation mode, reference mode.

Operation mode
 HMI: Enables equipment start and stop operation by means of HMI.
 Digital: Operates the equipment by means of DCS (DCS refers to the remote digital
control of the MVD, and for the specific interface definition, see Chapter VII - System
wiring - Fig. 7-5);
 Communication.: Achieves system control by means of communication.

Reference set
 HMI: Enables speed setting directly via HMI.
 Analog: Enables speed setting by means of analog input.
 Digital: Enables speed setting by means of DCS (DCS refers to the remote digital
control of the MVD, and for the specific interface definition, see Chapter VII - System
wiring - Fig. 7-5);
 Communication.: Enables speed setting by means of communication.
 PID: Enable PID function and the speed can be adjusted automatically...
Press "Param. Set" button in the HMI to enter into the parameter setting interface, as
shown in Fig. 3-11.
Fig. 3-10 operation mode interface
29