Setting⑥: Led Control - Mitsubishi Electric KD Series User Manual

Address Register name
7010 LedSelector
5-2-7 LED Control
[Function]
This function controls LED lighting.
On this product, the External LED pulse signal is output.
The format of output signals suppose the construction of
illumination which is shown below.
Glass
TM－XJ101C
5-2 Setting⑥: LED control
※On this product, LED Control functions as External LED pulse signal control.
R/W Val
LED lighting control
0: OFF (Signal is not output from OUT PULSE1 and OUT PULSE2)
1: Upper-stream side LED-A, one side lighting ON
R/W 0 to 3
2: Lower-stream side LED-B, one side lighting ON
3: Both Upper-stream LED-A and Lower-stream LED-B ON
Upper-stream side LED-A
Lower-stream side LED-B
(Signal is output from OUT PULSE1)
(Signal is output from OUT PULSE2)
(Signal is output from OUT PULSE1 and OUT PULSE2)
[Remark]
1) Sequential multiple different LED lightings (both
External LED and built-in LED) are not supported by
this product. In this case, White Correction cannot be
operated, too. When you select one of the LED control
modes, you can save White Correction data and run
White Correction.
2) As LED Control function, This product outputs External
LED pulse signal over External Connector L1. For more
details, refer to Page 49 and 55.
Result
© Mitsubishi Electric Corporation
Initial
0
70