Analog Devices AD9284-250EBZ User Manual page 7

AD9284-250EBZ User Guide
Setting Up the SPIController Software
After the ADC data capture board setup is complete, set up
the SPIController software using the following procedure:
1. Open the SPIController software by selecting Start >
SPIController or by double-clicking the SPIController
software desktop icon.
If prompted for a configuration file, select the appropriate one.
If not, check the title bar of the window to determine
which configuration is loaded. If necessary, choose
Cfg Open from the File menu and select the appropriate
file based on your part type. Note that the CHIP ID(1)
field should be filled to indicate whether the correct
SPIController configuration file is loaded (see Figure 7).
Figure 7. SPIController, CHIP ID(1) Box
2. Click the New DUT button in the SPIController window (see
Figure 8).
Figure 8. SPIController, New DUT Button
3. In the ADCBase 0 tab of the SPIController window, you can
access all global register settings (see Figure 9). See the
data sheet; the AN-878
Control Software; and the
to High Speed ADCs via SPI, for additional information.
4. Note that other settings can be changed on the ADCBase 0
page (see Figure 9) and the ADC A and ADC B pages (see
Figure 10) to set up the part in the desired mode. The ADCBase 0
page settings affect the entire part, whereas the settings on the
ADC A and ADC B pages affect the selected channel only. See
the AD9284 data sheet; the
Speed ADC SPI Control Software; and the
Note, Interfacing to High Speed ADCs via SPI, for additional
information on the available settings.
Rev. A | Page 7 of 24
Application Note, High Speed ADC SPI
AN-877 Application Note, Interfacing
Figure 9. SPIController, ADC Base0
AN-878 Application Note, High
AN-877
Figure 10. SPIController, ADC A Page
UG-178
AD9284
Application