Table of Contents
Advertisement
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you will not
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Problem
The SmartLine
appliance cannot be
switched on.
After the SmartLine
appliance has been
switched on or a sensor
control has been
touched, appears in
the timer display for a
few seconds.
The SmartLine
appliance has switched
off automatically. When
the appliance is
switched back on, an
appears above the On/
Off sensor control .
Possible cause and remedy
There is no power to the SmartLine appliance.
Check if the circuit breaker has tripped. Contact
an electrician or Miele (for the minimum fuse
rating, see data plate).
There may be a technical fault.
Disconnect the appliance from the mains
electricity supply for approx. 1 minute. To do this:
– switch off at the wall socket and withdraw the
plug, or
– switch off the mains circuit breaker or residual
current device.
If, after switching the circuit breaker or residual
current device back on, the appliance will still not
switch on, contact a qualified electrician or Miele.
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"System lock / Safety lock").
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
Clean off any dirt or remove the object (see
"Safety switch-off").
Problem solving guide
37
Advertisement
Table of Contents
