Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the the Miele Dealer.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.
Messages in the display
Issue
is flashing
alternately with in the
timer display and the
buzzer is sounding.
After the hob has been
switched on, or after
touching a sensor
control, appears in
the timer display for a
few seconds.
After the hob has been
switched on, appears
briefly in the timer
display. The hob does
not heat.
The hob has switched
off automatically. When
the hob is switched
back on, appears
above the On/Off
sensor control .
will flash alternately
with in the timer
display.
Cause and remedy
The hob is incorrectly connected.
Disconnect the hob from the mains electricity
supply.
Contact your Miele dealer. The hob must be
connected to the mains according to the wiring
diagram.
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"Safety features – System lock/Safety lock").
The hob is in demo mode.
Touch the 0 sensor control on any of the numerical
displays.
Then touch the and sensor controls at the
same time until flashes alternately with in
the timer display.
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
Clean off any dirt and/or remove the object (see
"Safety features – Safety switch-off").
The overheating protection mechanism has been
activated.
See "Safety features – Overheating protection".
Problem solving guide
51