Worktop Cut-Out For Flush-Fit Installation - Miele SmartLine Tepan Yaki Operating And Installation Instructions

Worktop cut-out for flush-fit installation

5,5 / 7
+0,5
Natural stone worktop
+ 0.5
* 7 mm with CS 7611 FL
Information for calculating the cut-out
The SmartLine appliances overlap the worktop by 10 mm.
When installing several SmartLine appliances, a distance of 2 mm must be
observed between the individual SmartLine appliances.
Calculating cut-out dimension A
1 SmartLine appliance = width of the appliances plus 2 mm on the right, plus
2 mm on the left.
Several SmartLine appliances = total width of the appliances plus 2 mm distance
between the SmartLine appliances, plus 2 mm on the right, plus 2 mm on the left.
Calculating cut-out dimension B = cut-out dimension A minus 12 mm on the right,
minus 12 mm on the left.
Some examples are illustrated below.
52
ß R 4
*
+ 0,5
0 2
12
B
A
A
B
/ 7
5,5 + 0,5
+0,5
12
Wooden worktop
*
0 2
B
A