Table of Contents
Advertisement
Granite and marble worktops
You will need heavy-duty double-side
tape (not supplied) to secure the
spacer bars.
Stick the tape onto the upper edge of
the cut-out or onto the lower step of
the stepped cut-out.
Position the spacer bars flush onto
the upper edge of the cut-out or onto
the lower step of the stepped cut-out.
Press the spacer bars firmly into
place.
Installing the SmartLine
appliances
Stick the supplied sealing strip under
the edge of the SmartLine
appliances. Do not apply the sealing
strip under tension.
Feed the mains connection cable
down through the cut-out.
Position the SmartLine appliance in
the worktop cut-out. When doing this,
make sure that the seal of the
appliance sits flush with the worktop
on all sides. This is important to
ensure an effective seal all round.
Surface-mounted installation
If the seal does not meet the worktop
correctly on the corners, carefully
scribe the corner radii (≤ R4) with a
jigsaw.
Do not use any additional sealant
(e.g. silicone) on the SmartLine
appliance.
Connect the SmartLine appliance to
the mains electrical supply.
Check that the SmartLine appliance
works.
Seal the gaps between the individual
appliances with a silicone sealant that
is heat-resistant to at least 160 °C.
Installation
57
Advertisement
Table of Contents
