Table of Contents
Advertisement
Fire hazard!
Do not leave the Tepan plate
unattended whilst it is being used.
Please note that the heating-up time
for induction is much shorter than for
conventional electric heating.
Switching on the Tepan plate
Touch the sensor.
Further sensor controls will light up. If
no further entry is made, the Tepan
plate will switch itself off after a few
seconds for safety reasons.
Setting the power level
Touch the appropriate sensor control
on the respective numerical keybank
for the power level you want.
Switching off
To switch off a cooking zone, touch
the 0 sensor control on the numerical
keybank for that zone.
To switch off the Tepan plate and
thus both cooking zones, touch
the sensor control.
Residual heat indicator
If the SmartLine applinace is still hot,
the residual heat indicator will light up
after it has been switched off.
Depending on the temperature, a dot
will appear above power levels 1, 2 and
3.
The dots of the residual heat indicator
go out one after the other as the
SmartLine appliance cools down. The
last dot only goes out when the
SmartLine appliance is safe to touch.
Danger of burning!
Do not touch the SmartLine
appliance whilst the residual heat
indicators are lit up.
Operation
21
Advertisement
Table of Contents
