Fantasea Line FG7X II S Instruction Manual page 9

Front Side of Housing -
12. Lanyard Loop
7. Fiber Optic Cable Plate-
a. When installed on the housing, the fiber optic cable plate and the two adaptors inserted
inside it allow for an easy attachment of 2 fiber optic cables to the housing. For further
instructions, please refer to the section "External Flashes".
b. Remove the fiber optic cable plate from the housing in order to make use of the internal
camera flash during your dive. In order to remove the plate, insert your fingers beneath the
adaptors installed inside the plate and pull the plate upwards till it is removed from its slot.
Note that when photographing using the camera built-in flash only, the flash diffuser
accessory should be installed, or else unwanted shading will occur in most images taken.
c. Make sure the fiber optic cable plate is secured to the housing by its secure line in order to
avoid losing it during the dive.
d. If using only one external flash, make sure the second fiber optic cable adaptor remains in its
place to block any light coming out of the exposed adaptor hole.
Corresponding numbered descriptions are found below the image
11. Tripod Mounting Screw Holes
(bottom)
FG7X II S Housing Instruction Manual 20220601
9
7. Fiber Optic
Cable Plate
8. Flash Up Switch
(on side)
9. Control Ring
10. Lens Port