6.6.3
M150 WINDROWER
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Lower header to ground. If ground is soft, place
blocks under header.
b. Stop engine and remove key.
c. Move LH (cab forward) platform to rear of
windrower.
d. Disconnect the hydraulic coupler from windrower
valve.
C
e. Raise lever (A) and undo Velcro straps (B).
f.
Move hose (C) to store on header.
Form # 169455
B
A
OPERATION
g. Install caps on connectors and hose end if
equipped.
h. At the header, disconnect electrical connector by
turning collar counterclockwise and pulling
connector to disengage.
i.
Disconnect the two drive couplers, and case
drain coupler on header.
j.
Move hose bundle from header and locate on
windrower LH side with hoses in support (D).
k. Rotate lever (A) clockwise and push to engage
bracket.
l.
Locate electrical harness through support (D)
and attach cap to electrical connector (E).
m. Move windrower platform back to closed
position.
n. Detach header from windrower.
Self-Propelled Windrower Operator's Manual.
24
E
A
D
Refer to the
Revision A