Header Attachment - MacDon R85 Operator's Manual

6.5 HEADER ATTACHMENT

a. If not installed, attach the forming shield to the
windrower:
A
1. Remove the two clevis pins (A) from forming
shield forward end.
2. Position forming shield under the windrower
frame.
B
3. Locate forming shield onto spacers (B) on
windrower legs and secure with clevis pins
(A) and lynch pin.
Form # 169455
OPERATION
A
b. Attach the R85 header to the Windrower. Refer
c. Connect the hydraulics and electrical harness.
15
C
4. Lift the aft end of the forming shield and
attach straps (C) to pins (D) on windrower
frame. Install washer and hairpin to secure
strap. Use the middle hole and adjust height
to suit the crop.
BOTH SIDES
G
F
5. Set forming shield side deflectors to desired
width by repositioning adjuster bars (E).
Use same hole location on both sides.
6. Adjust fluffer shield (F) to middle position.
Loosen handles (G) if required.
to the MacDon Self-Propelled
Operator's Manual, and then return to this
manual to complete the attachment.
See applicable section in the following pages for
your windrower model.
D
E
Windrower
Revision A