Nuvo INVU User Manual page 45

Session Preparation Guidelines
The session preparation guidelines screens provide instructions on how to prepare and wear
your INVU Sensor Band™ and are described in detail in section 6.5.1.
After following the preparation guidelines and applying the INVU Sensor Band™, press "WI-
FI ENABLED" on the last session preparation guidelines screen. The "all set" screen is shown
and pressing "START TRAINING SESSION" will start the training session process.
During the training session, we check the signal of your band continuously. If we detect a
weak signal, we will guide you through improving it. Training ends after a good band signal
has been detected for a few minutes.
Note: No clinical monitoring of you or your baby is done during training.
Note:
For a successful training session, please try to minimize your movements during the
process.
Note:
The blue light on the band Controller blinks until the training session ends or until a
weak signal or errors are detected. This indicates that the process is working properly, and
that data is transferring via the Bluetooth connection to your smartphone.
Tips for a successful monitoring session!
✓ Scrub your abdominal skin with soap and water before applying the band.
✓ Make sure you are connected to a Wi-Fi network.
✓ Start the training session at a comfortable relaxed position: sitting, reclining or laying
on your back.
✓ Minimize your movements as much as possible during the training session.
✓ Pay attention to INVU app sounds and notifications during the training session.
NV-UMLS-0012
Figure 6-13. Last preparation instruction and all set
Invu by Nuvo™User Manual
The INVU™ App
39