Attaching The Drum Unit To The 3 Point Hitch - IBEX TS51C Assembly Manual

ASSEMBLY GUIDE

ATTACHING THE DRUM UNIT TO THE 3 POINT HITCH

Place the drum unit so that it is oriented as shown in Figure 11. Be sure the PTO spline shafts
face each other.
Figure 11 drum unit positioned in relation to the 3-point hitch frame
To connect the 3 point hitch frame to the drum unit, first get the larger lift arm with a swivel
tee attached to it, shown in Figure 12. Remove the cap of the tee and place it on top of the
drum unit with the tee facing the 3 point hitch. Slide the tee into the 3 point hitch frame and
install the cap as shown in Figure 13, threading the nut only until you feel some resistance. The
nut will be removed later when mounting the top arm. Wait to attach the other end of the
lower arm until after the next step.
Figure 12 lower lift arm and swivel tee in place
2022-1.1 IBEX EQUIPMENT CO. 6