IBEX TS51C Assembly Manual page 6

ASSEMBLY GUIDE
Figure 3 larger guard installed on the gearbox facing the tractor
The small guard with a cutout is installed on the 90 degree gearbox on the other side, with the
cutout facing the rear. This cutout provides space to allow the PTO shaft to pivot to 90 degrees
when the mower is switched to transport mode. This guard is normally already installed.
Figure 4 smaller guard with cut-out facing the rear (cutout may look different than picture)
Get the small guard without a cutout and use the set of 3 small screws and washers to install it
at the drum unit PTO connection as shown in Figure 5.
2022-1.1 IBEX EQUIPMENT CO. 2