IBEX TS51C Assembly Manual page 11

ASSEMBLY GUIDE
Figure 13 lower lift arm in place
To install the top arm ("spring arm"), first support the lower arm as shown in Figure 14 with a
2 foot length of 2x4 or a floor jack. Doing this will prevent the pivot pin from falling out of the
sleeve when the cap is removed. Attach the top spring arm around the cap as shown in Figure
14 and secure the nut and bolt. Fully secure the nut this time, but do not over-tighten it as the
pin needs to be able to pivot. The 2x4 / jack is no longer needed at this point.
Figure 14 top spring arm installed with pin blocked up by using a 2x4
2022-1.1 IBEX EQUIPMENT CO. 7